Waching daily Nov 3 2018

Take the machine out of the box

Remove machine protection film

Check the accessory box

1.power cable 2. Card reader 3.Data cable 4.Camera cable 5. 3M tape 6.Plastic scraper

7. Switch line 8. Motor line 9. Wrench 10 SD card 11 Filament rack

Remove the tie and wrap which fixed the print bed with scissors

Use a 2.5mm wrench to remove the screws of the two brackets

Disassembled the filament

Assembly the filament rack

Install the filament

Pull the filament out of the tube by about 20cm and straighten the end of the filament.

Press the handle of the extruder with your right hand,

and insert the filament into the feed port with your left hand

The insertion depth is about 5cm

Go to the Filament In and start heating

And the other nozzle is the same

Start to leveling

Move the screw according to the information on the screen

Put the SD card into the machine

Click "Print from SD card" and choose a test print

Use the plastic scraper to remove the model along the edge of the model

or you can remove the platform and remove the model